TUTORIAL:

This centerpiece was created with two shapes, a rectangle and an "S" shape. These two shapes are coiled and attached together. Thinner wire is then used to attach beads and ornamentation. The centerpiece was used on a bracelet, but with a few adjustments can be adapted to a necklace. There are four small loops stemming out of the centerpiece, to which pearls or beads can be strung forming a bracelet.

• 2 feet 18 or 16 ga soft round wire
• 10.5 feet 28 or 26ga soft round wire
• 2 3mm rhinestones set on prongs
• 4 3mm silver Bali spacers
• 2 barrel 6mm Bali beads
• Approx. 14 2mm round beads
• Approx. 40 1mm round beads
• Note: quantity of small beads might vary according to the exact spacing of piece.

• Flat nose pliers
• Chain nose pliers
• Round nose pliers
• Flush wire cutter
• Chasing hammer
• Metallic block or anvil
• A thick piece of wire or thin knitting needle